It is the cache of ${baseHref}. It is a snapshot of the page. The current page could have changed in the meantime.
Tip: To quickly find your search term on this page, press Ctrl+F or ⌘-F (Mac) and use the find bar.

Penggunaan Jerk untuk Deteksi Dini Kerusakan Bantalan Gelinding dan Pemantauan Kondisi Pelumasan | Abidin | Jurnal Teknik Mesin

Penggunaan Jerk untuk Deteksi Dini Kerusakan Bantalan Gelinding dan Pemantauan Kondisi Pelumasan

Zainal Abidin, Budi Heryadi




Abstract


This paper describes the use of jerk signal, a signal obtained from differentiation of the acceleration signal with respect to time, for detecting the early damage of a bearing and bad lubrication conditions. The use of jerk signal is expected to result more sensitive detection than that obtain using acceleration signal. To prove this hypothesis, this paper shows the results of vibration measurement for needle bearings and taper roller bearings with variation of load level, types of bearing damage, and lubrication condition. Comparisons of acceleration and jerk signals are performed in both time domain, by comparing their RMS values, as well as in frequency domain, by comparing their spectrums. The results of the experiment show that the use of jerk signal can give a more sensitive result in detecting bearing damage than that produced using acceleration signal. Moreover, the use of jerk signal can lead to better results in detecting bad lubrication of rolling bearing than that obtain using Crest Factor (CF) value.


Keywords


Jerk, acceleration, bearing, lubrication conditions.

Full Text: PDF

The Journal is published by The Institute of Research & Community Outreach - Petra Christian University. It available online supported by Directorate General of Higher Education - Ministry of National Education - Republic of Indonesia.


Copyright © Research Center Web-Dev Team